Remote Control Transmitter 2 Channels Rolling Code Genius Amigo Ja332 868 Mhz Kilo

GENIUS

KILO TX2 868MHZ

ROLLING CODE

2-channel

ORIGINAL

Procedure for duplication:

1. Press the first 2 keys of the at the same time
MASTER radio control already working in the receiver**
and hold them down until their LED flashes. Release both buttons.

2. While the LED is flashing, move the vehicle towards the front
MASTER radio control already working in the receiver to the NEW radio control (to be coded).

3. On the MASTER radio control (already working in the receiver),
while the LED is still flashing, press and hold
press and hold the first key you want to duplicate. Its LED will light up steadily.

4. Press the button on the new remote control (to be coded).
equivalent to be copied and released only when its LED has not flashed twice.

5. Release the MASTER radio control key (already working in the receiver).

6. Repeat the procedure for all the keys you want to duplicate.

If the procedure should not be successful or if errors should be made during the
programming, wait 20 seconds and start again from point 1.
*To recognize a Master remote control, press any button on the remote control already
working in the receiver and check what type of flashing its LED emits:
- if it emits a short flash before turning on with a fixed light it is a MASTER and can
be duplicated by following the procedure described on this page.
- if it turns on immediately with a fixed light, it is a SLAVE remote control and cannot
be duplicated. In this case you will have to contact only the installer who has you
the automation is mounted.
**Be careful not to confuse the two remote controls: the MASTER remote control is already functioning
receiver with the new one to encode