Genius Transmitter Kilo Kilo2 Tx2 Gate Automation Remote Control Jlc 868 Mhz

GENIUS

KILO TX2 868MHZ

ROLLING CODE

2-channel

ORIGINAL

Procedure for duplication:

1. Press the first 2 keys of the at the same time
MASTER radio control already working in receiver**
and keep them pressed until the LED flashes. Release both buttons.

2. While the LED is flashing, approach the front
MASTER radio control already working in the receiver to the NEW radio control (to be coded).

3. On the MASTER radio control (already working in the receiver),
While the LED is still flashing, press and hold
press and hold the first key you want to duplicate. Its LED will light up steadily.

4. Press the key on the new remote control (to be coded).
equivalent to be copied and released only when its LED has not flashed twice.

5. Release the MASTER radio control key (already working in the receiver).

6. Repeat the procedure for all the keys you want to duplicate.

If the procedure is not successful or if errors are made during the
programming, wait 20 seconds and start again from point 1.
*To recognize a Master remote control, press any button on the remote control already
working in the receiver and check what type of flashing its LED emits:
- if it flashes briefly before turning on with a fixed light, it is a MASTER and can
be duplicated by following the procedure described on this page.
- if it turns on immediately with a steady light it is a SLAVE remote control and cannot
be duplicated. In this case you will have to contact exclusively the installer who has you
the automation is mounted.
**Be careful not to confuse the two remote controls: the MASTER remote control is already functioning
receiver with the new one to be coded