Benincà Trust24 917603001 24 Vdc Control Unit, Automation Systems

24 Vdc control unit with integrated receiver and battery charger

Mod. TRUST24

SKU: 917603001

24 Vdc
Control unit that manages the encoder device for maximum precision during automation operating cycles
Encoder signal recreated by the control unit based on measurements of the electric motor's operating parameters. Optimal deceleration management is possible, as is tracking the gate's travel and delivering torque according to its position to ensure maximum safety
Intelligent power control system that acquires dynamic data through precise torque calculations. The STC System identifies potential critical points by adjusting torque according to measured performance and actual requirements
433.92 MHz receiver with exclusive Advanced Rolling Code (ARC) encryption
Function that automatically adjusts operating parameters to simplify system installation and commissioning
Option to set the number of cycles after which a maintenance request warning is triggered on the system
Allows a programming protection code to be set for the control unit, preventing access to menus and changes to parameters
Ready for connection of X.BE (KNX) and Q.BE (MQTT) accessories
Ready for control unit management via the BeUP app and the pro.UP accessory, which recreates the control unit menu and allows you to adjust parameters and logic, read error messages, and update firmware. Remote diagnostics can be performed, gate status checked, and commands sent
512 transmitters can be stored in the receiver
Standby power consumption compliant with European Regulation (EU) 2023/826

APPLICATION

1 or 2 actuators for swing gates

CONTROL UNIT POWER SUPPLY

100 ÷ 250 Vac - 50/60 Hz

MOTOR POWER SUPPLY

24 Vdc / 130 W + 130 W

MAIN FUNCTIONS

Integrated LCD display
Integrated 433.92 MHz radio receiver, 512 codes, ARC radio encoding
Plug-in terminal blocks
Separate limit switch inputs for each motor
Automatic, semiautomatic and hold-to-run operating logic
Separate encoder inputs for each motor
Open, close, step-by-step, pedestrian and stop inputs
Input for photocell active during opening and closing, and photocell active only during closing
Input for N.C. or 8K2 safety edge
12/24 Vdc electric lock output
Two outputs configurable as gate-open indicator, courtesy light, area light, second radio channel, photocell test, flashing light or alarm contact
Automatic operating parameter setup
Electronic torque adjustment, separate for each motor
Anti-crushing safety with amperometric detection and encoder management
Electronic torque adjustment with automatic calculation for each point along the travel (STC SYSTEM)
Deceleration zones adjustable separately for each motor
Can operate using an encoder or timed operation (managed via virtual encoder), independently for each of the two motors
Integrated ESA+ energy saving
Ready for KNX connection via X.BE board (optional)
Ready for management, configuration, diagnostics and firmware updates via the BeUP app using the PRO.UP accessory
Parameter configuration and remote control management via the Advantouch system
Cycle count
Access and programming password
Maintenance warning
Integrated battery charger
Standby power consumption compliant with European Regulation (EU) 2023/826

TECHNICAL DATA:
Control unit power supply: 100 ÷ 250 Vac - 50/60 Hz
Motor power supply: 24 Vdc / 130 W + 130 W
No. of storable codes: 512
Encoder: Yes
Virtual encoder: Yes
Inverter technology: No
STC System: Yes
ARC O

24-month warranty

eb: 236300123835